TN-330 360 Toner Reset Instruction

Description:

The reset gear on the toner cartridge did not properly contact and reset the New Toner Sensor within the printer. The reset gear will operate only once after the toner cartridge is installed and the position of the gear cannot be reset after installation. To reset the Toner Life Display, a manual reset procedure must be performed. 

Solution:

The following steps will need to be performed to manually reset the toner life.

DCP Printer Series 

1.    Open the front cover.

2.    Press the Clear/Back button on the control panel.

The display will read “Replace Drum 1. YES 2. NO” (DISREGARD THIS MESSAGE) Proceed to step 3.

3.    Press the start button, press the up or down arrow key until “00” appears on the LCD display and then press OK.

4.    Close the front cover and the operation has now been completed.

MFC Printer Series

1.    Open the front cover.

2.    Press the Clear/Back button on the control panel.

3.    Press in order *,0,0.

4.    Close the front cover and the operation has now been completed. 

HL Printer Series

1.    Open the front cover.
2.    Turn on the power switch while holding down the “GO” (Blue LED) button until all LEDs on the control panel light up. (approx. 5 seconds)
3.    Release the “GO” button and check that all LEDs are off.
4.    Press the “GO” button twice, pause then press the “GO” button six times for TN-330(Standard Yield) Toner, or seven times for TN-360 (High Yield) Toner.
5.    Close the front cover and the operation has now been completed.

-End-